Parkside PLEM 50 B2 User Manual

15 GB
Remove the used batteries from the battery compartment
5a
,
if necessary.
Insert the (new) batteries. Ensure the correct polarity as shown
on the diagram inside the battery compartment
5a
.
Replace the battery compartment cover
5b
as shown (fig. A).
Start-up
Power ON / OFF
Press power button
11
to power on the product.
Press and hold the power button
11
until the LC display turns
off to power off the product.
Note: If no button is pressed for 3 minutes, the product will
automatically power off itself.
Acoustic signal:
- Each press of a button and every error-free function that is carried
out is confirmed by a short beep.
- A double beep will be heard in the event of any fault.
- Under continuous measurement mode, fast pace of short beeps will
be continuously heard and in the event of error, the fast pace
double beep will slow down.
- Briefly press the beep button
13
to activate or deactivate the
beep sound at any mode.

Parkside PLEM 50 B2 Specifications

General

Brand	Parkside
Model	PLEM 50 B2
Category	Measuring Instruments
Language	English