9
GB
Several positions are possible for the
bow handle.
Nevervacuumwithoutalter!
6. Fit the power cable holder (4) onto the
motor head (3) and screw it in place
with 2 crosshead screws.
- Connect the suction hose (21).
- Fit the handle (22)
- Fit the telescopic suction pipe (19).
(Press the knob on the telescopic
suction pipe in the
direction and
separate to the desired length).
- Fit the desired nozzle (27/28).
To store the suction set during breaks,
push together the telescopic suc-
tion hose and plug the suction pipe
holder into the socket on the motor
housing (see picture
below).
Operation
Switching on/off
Connect the mains plug.
in the chapters “dry vacuuming“
and “wet vacuuming“).
Switching On:
On/Off Switch (see
6) In position “I“
Switching Off:
On/Off Switch (see
6) In position “0”
Dry vacuuming
head (3). The sealing lip that curves
upward must point away from the mo-
tor head.
Vacuumingnedust:
than usual. For this reason, we
bag (26) down on the perforation.
(26) and pull it over the internal suc-
tion nozzle (8) in the stainless steel
container (9). The connector on the
suction nozzle must be completely en-
bag opening.
Wet vacuuming
the motor head (3).
When the container is full, the suc-
and suction is then cut off.
Switch the appliance off, remove
the plug from the socket and empty
the container (see “Cleaning/Main-
tenance/Storage”).
If foam or liquid exits, switch off the
machine immediately.
To Next Page
Loading...
Need help?
General
