32
Disposal/
environmental
protection
The device, accessories and packaging
should be properly recycled.
Electrical devices must not be dis-
posed of with domestic waste.
The symbol of the crossed-out wheeled bin
means that this product must not be dis-
posed of as unsorted municipal waste at
the end of its useful life.
Directive 2012/19/EU on waste
electrical and electronic equip-
ment:
Consumers are legally obliged to recycle
electrical and electronic equipment in
an environmentally sound manner at the
end of its life. In this way, environmentally
friendly and resource-saving recycling is
ensured.
Depending on the implementation in na-
tional law, you may have the following op-
tions:
• Return to a shop,
• Hand over to an official collection
point,
• Return to the manufacturer/distributor.
This does not affect accessories enclosed
with the old devices or tools without any
electrical components.
Troubleshooting
The following table will assist you in fixing faults:
ProblemPossible causeError correction
No mains power supplyCheck the socket, mains con-
nection cable, plug and fuse
and have them repaired by a
qualified electrician if neces-
sary.
On/Off switch (10) is
broken
contact the service centre.
Device does not start
Defective motorcontact the service centre.
Reduce pressure on attach-
ment tool
Engine is slowing down and
stops
Device is overloaded through
workpiece
Workpiece unsuitable
Device works with interrup-
tions
Internal loose contact
On/Off switch (10) is
broken
contact the service centre.
Milling progresses unevenlyParallel guide (15) not inser-
ted
Fitting and removing the par-
allel guide, p.27
To Next Page
Loading...
Need help?
General
