33
ProblemPossible causeError correction
Unsuitable or blunt cutterChange the cutterWorkpiece has burn marks
Milling depth is too largeSetting the milling depth,
p.28
Cutter is worn and diffuseEdges of the milling tear out
Grooves and unevenness in
the milled surface
Cutter blades are damaged
Change the cutter
Vacuum cleaner not switched
on
Switch on vacuum cleaner
before milling
Dust is not extracted
Suction hose or adaptor
for external dust extraction
blocked
Removing obstructions and
blockages
Spare parts and accessories
You can get spare parts and accessories from www.grizzlytools.shop. If
you have any problems with your order, contact us via our online shop. If you have any
other questions, contact the Service Centre, p.35
Pos. nr.NameOrder No.
7 + 142× Collet chuck, 8 mm + 6 mm91110537
15 + 18Parallel guide + 2× Sliding bar91110532
19Depth stop91110528
20Adapter for external dust extraction91110529
31Centring tip91110533
32Template guide91110531
6-part cutter set91110536
Service
Guarantee
Dear Customer,
This product is provided with a 3 year
guarantee from the date of purchase.
In case of defects, you have statutory
rights against the seller of the product.
These statutory rights are not restricted by
our guarantee presented below.
Terms of Guarantee
The guarantee period begins on the date
of purchase. Please retain the original re-
ceipt. This document is required as proof
of purchase.
If a material or manufacturing defect oc-
curs within three years of the date of pur-
chase of this product, we will repair or
replace – at our choice – the product
for you free of charge. This guarantee re-
quires the defective product and proof of
purchase to be presented within the three-
year period with a brief written description
of what constitutes the defect and when it
occurred.
If the defect is covered by our guaran-
tee, you will receive either the repaired
To Next Page
Loading...
Need help?
General
