Parkside PPS 200 C2 User Manual

PPS 200 C2
■ 6
│
GB
│
IE
│
NI
│
CY
Operation
Switching on and off
Switching on
♦ Press the ON/OFF switch0 to position "I".
Switching off
♦ Press the ON/OFF switch0 to position "0".
Fitting the sanding sheet
WARNING!
► Always remove the plug from the mains
power socket before carrying out any work
on the appliance.
NOTE
► Before fitting a new sanding sheet 7, remove
any dust and dirt from the sanding plate 6,
8 and 9.
► Ensure that the extraction holes on the sanding
sheet match up with those on the sander plate.
♦ Position the sanding sheet 7 flush on one side
of the sanding pad 6, 8 and 9.
♦ Then place the sanding sheet 7 on the sanding
pad 6, 8 and 9 and press it firmly into
place.
Different materials require different grain sizes.
You can find out which grain is suitable for which
work in our non-binding recommendations in
"Work instructions, tips and tricks".
Extracting dust
Wear a dust mask!
WARNING! RISK OF FIRE!
► When working with power tools that are fitted
with a dust collector 3 or can be connected
to a vacuum cleaner via the vacuum cleaner
adapter, there is a risk of fire! In unfavourable
conditions, e.g. when sparks are flying while
sanding metal or metal residues in wood,
wood dust in the dust sack (or in the vacuum
cleaner dust bag) can spontaneously ignite.
This is a particular risk if the wood dust is
mixed with paint residues or other chemicals
and the workpiece has become hot after
being worked for a long time. Therefore, do
not allow the workpiece to overheat and
always empty the dust collector 3 or the
dust bag in the vacuum cleaner before taking
a break from work.
Dust extraction with dust collector
Attaching the dust collector
♦ Push the dust collector 3 onto the appliance.
Removing the dust collector
♦ Pull the dust collector 3 off the appliance.
NOTE
► To ensure optimum extraction, regularly empty
and shake out the dust collector 3. To do so,
press the release button 2 to pull the rear
part of the dust collector 3 off the appliance.
► Perforated sanding sheets are required for
dust extraction.
Dust extraction using an external extraction
device
Connection
♦ To remove dust using a vacuum cleaner, push
the suction hose of a suitable dust extraction
device (e.g. a workshop vacuum cleaner) onto
the nozzle4.
NOTE
► If necessary, use the adapter5 by pushing it
into the nozzle4.

Parkside PPS 200 C2 Specifications

General

Brand	Parkside
Model	PPS 200 C2
Category	Sander
Language	English