PTHSA 20-Li B3
GB
│
IE
│
9 ■
■ Use only the additional equipment and accesso-
ries specified in the operating instructions. Using
attachments or accessory tools other than those
recommended in the operating instructions can
lead to a risk of injury.
Additional safety instructions
■ Make sure that there are no bystanders or
animals within a radius of 15 metres when
using the tool. The operator is responsible for
third parties within the working area.
■ Keep the appliance, the cutting mechanism and
the blade guard in good condition to prevent
injury.
■ Children must be supervised to make sure that
they do not play with the appliance.
■ Do not use the appliance until you have famil-
iarised yourself with its use.
■ Do not work with a damaged or incomplete
appliance or an appliance that has been modi-
fied without the consent of the manufacturer.
Never use the appliance with defective protec-
tive equipment. Do not use the appliance if it
has a defective on/off switch. Before use, check
the safety condition of the appliance, especially
the blade and the saw chain. If the appliance
has been dropped, check for significant
damage or defects.
■ Never start the appliance before it is correctly
assembled.
■ When starting and operating the appliance,
ensure that it does not come into contact with
the ground, stones, wire or other foreign mate-
rial. Switch off the appliance before you put it
down.
■ The appliance is designed for two-handed oper-
ation. Never work with one hand. Make sure
that the appliance is switched off when relo-
cating the appliance and that you cannot acci-
dentally touch the on/off switch. Carry the
appliance with the blade facing backwards. Fit
the blade guard during transportation.
Before use
Charge battery pack (see fig. B)
CAUTION!
► Always unplug the appliance before you
remove the battery pack from or connect
the battery pack to the charger
.
NOTE
► Never charge the battery pack at an ambient
temperature of below 10°C or above 40°C.
If a lithium-ion battery is going to be stored
for an extended period, the charge level
should be checked regularly. The optimum
charge level is between 50% and 80%. The
storage climate should be cool and dry and
the ambient temperature should be between
0°C and 50°C.
♦ Connect the battery packr to the high-speed
battery chargerz (see fig. B).
♦ Insert the power plug into the socket. The green
charge control LEDp lights up briefly, then the
red control LEDo lights up.
♦ The green charge control LEDp indicates that
charging is complete and the battery packr is
ready for use.
CAUTION!
♦ If the red control LEDo flashes, this means
that the battery packr has overheated and
cannot be charged.
♦ If the red and green control LEDs o/p both
flash, this means that the battery packr is
defective.
♦ Push the battery packr into the appliance.
♦ Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
IB_373422_PTHSA20-LiB3_LB8.indb 9 18.11.2021 12:13:09
To Next Page
Loading...
Need help?
General