To Next Page

To Previous Page

Refer to Chapter I, preinstallation, Section D. Chimney,

or Vent for installation requirements. Refer to

Chapter 9. Startina the Boiler, Section C. Run Burner

Check Out for damper settings and draft requirements.

r:! I:{II:|L_I:I;t r:1:J'Jl[l'Y:_li[e]{

1. Refer to Burner Spec and Data Sheets for the Oil

and Gas/Oil Burners pre-tested with Series LC

boilers.

2. Make sure the nozzle sizing and spray pattern match

those given in the spec and data sheets.

[I,_ hVA[ellJL_ll I1:1: I:|II:|LII=I_

3. See Figure 26 and Table 13 for combustion chamber

dimensions.

I:_ IIL_-"]llr±!llli:]lJ-'_,_l=l;! I_v_[_l|JL_illlh_[ClI;.lff-_lll

I. The Burner Mounting Plate is made to fit the burner

being used. Burners vary in bolt pattern for the

flange, burner tube diameter, insertion length and

near-tube configuration. Make sure the front plate is

correct for your burner if purchased separately from

the boiler.

2. Remove the Burner Mounting Plate and Hardware

Bag from the crate.

Screw (7) 3/8"-16 x 21/4"studs into the holes in the

front section around the chamber opening.

Secure the Burner Mounting Plate to the front

section with the fiat washers and hex nuts.

Remove the Burner from its crate. Read the burner

instructions.

Insert (4) 3/8"-16 x II/4'' studs supplied with Burner

Mounting Plate into the front plate holes.

Place the high temperature gasket on the burner

front plate and secure the burner to the front plate

with 3/8" fiat washers and hex nuts.

If the burner is supplied with a pedestal, install it to

the burner per the Burner Manufacturer's

Instructions. The pedestal provides additional

support and prevents the burner from sagging.

PEERLESS LC SERIES User Manual

Questions and Answers: