Perlick HA24RB User Manual

PROBLEM CAUSE SOLUTION
Compressor is not running.
No power to compressor.
Check wiring to compressor.
Check where power is interrupted between
controller and compressor.
No call for cooling from control.
Check control settings or for bad control.
Incorrectly wired connections in machine
compartment.
Verify wiring per wiring diagram,
Section 8.2.
Incorrect control settings.
Return to factory settings.
See
Section 8.6.
Faulty control.
Refer to Control not functioning.
Starting device is not operational (start
relay/capacitor).
Replace compressor electrical components.
Faulty compressor.
Check compressor, see
Section 7.9
Condenser fan is not run-
ning.
No power to fan
Restore power to unit.
Refer to information plate. See
Section 1.0 and Table 8-1
Incorrectly wired.
Verify wiring per wiring diagram,
Section 8.2.
Fan is obstructed.
Remove obstructions.
Fan still does not run.
Replace condenser fan per
Section 7.0.
Evaporator fan is not run
-
ning.
Faulty/defective door switch or wiring to
door switch.
Check wiring and continuity of switch con
-
tacts. Replace switch if defective.
Missing or misaligned door switch plunger
bracket.
Install bracket and/or align.
No power to evaporator fan motor.
Restore power to unit.
Refer to information plate. See
Section 1.0 and Table 8-1
Fan is obstructed.
Remove obstruction.
Incorrectly wired.
Verify wiring per wiring diagram,
Section 8.2.
Return to Table of Contents
Residential Refrigeration
and Front Venting Commercial Refrigeration
Service Manual
Electrical System
Troubleshooting Guide - Electrical System Page 3-4

Perlick HA24RB Specifications

General

Brand	Perlick
Model	HA24RB
Category	Refrigerator
Language	English