or
TRIP: access to the trip
computer displays.
Each successive press on the button
located at the end of the wiper stalk
displays different information.
Zero reset
When the required trip is displayed,
press the control for more than
two seconds.
With the exterior lighting on, press the
button to vary the intensity of the ligh-
ting of the instruments and controls.
When the lighting reaches the mini-
mum (or maximum) setting, release
the button then press it again to in-
crease (or reduce) the brightness.
As soon as the lighting is of the re-
quired brightness, release the button.
- the "vehicle" tab with:
the range,
the current fuel
consumption
the distance
remaining.
- the trip "1" tab with:
the distance travelled,
the average fuel
consumption,
the average speed,
for the fi rst trip.
- the trip "2" tab with:
the distance travelled,
the average fuel
consumption,
the average speed,
for the second trip.
Trips "1" and ''2' ' are independent but
have identical application.
Trip "1" for example allows you to
make daily calculations and trip "2"
monthly calculations.
To Next Page
Loading...
Need help?
General
