Pfaff hobbylock 799 User Manual

Opening and closing
looper
cover
and
work
support
Push
looper cover 12 fully
to
the
right,
hold it, and swing
it down.
To close
the looper cover, push it up
until it
locks.
To
open work support
15, push it in
the direction shown
by the arrow. To
close
the work support,
push
it lightly
until
it locks.
Selecting stitch
types
Stitch types 1 to
8
are illustrated
on
the machine behind
the
looper
cover.
The
needle combinations (A, B and
C)
and the thread
tensions used are
colourcoded.
A needle chart with the
corresponding
set screws is printed
underneath.
Important!
While the looper
cover or work
sup
port is
open, power supply to the
machine
is interrupted.
Important!
A
While the looper
cover or work sup
port
is
open, the power supply to the
machine is cut off.
Threading
paths for different stitch
types on the rear side of the waste
box.
On the
righthand side the stitch types
(1 to 8) with the corresponding threa
ding points
A are indicated.
Each
threading path has its own colour.
Move the slide
so that
threading point
A for the required stitch type (1
to
8)
is
coloured
orange.
Now thread all colourcoded threading
paths, see pages 8 to 1 2.
Indication
B shows
you
whether the
overedge
looper must be engaged or
disengaged
(see
pages
33, 34).
Please
note Only the eight stitch
types on the rear
side of
the
waste box
can
be set using the slide.
Other sttch types
are
shown in the
stitch
selection table (pages 44 to 51).
7

Pfaff hobbylock 799 Specifications

General

Brand	Pfaff
Model	hobbylock 799
Category	Sewing Machine
Language	English