13. Wireless and
Networks
13.1. Home Network
To enjoy the full capabilities of your Philips Smart TV,
your TV must be connected to the Internet.
Connect the TV to a home network with a high-speed
Internet connection. You can connect your TV wirelessly
or wired to your network router.
13.2. Connect to Network
Wireless Connection
What You Need
To connect the TV to the Internet wirelessly, you need a
Wi-Fi router with a connection to the Internet. Use a high-
speed (broadband) connection to the Internet.
Make the Connection - Wireless
(Home) > Settings > Wireless & networks > Wired or
Wi-Fi > Connect to network > Wireless (Wi-Fi)
1 - In the list of found networks, select on your wireless
network. If your network is not in the list because the
network name is hidden (you switched off the SSID
broadcast of the router), select Add New Network to
enter the network name yourself.
2 - Enter your encryption key. If you entered the
encryption key for this network before, you can
select OK to make the connection immediately.
3 - A message will be shown when the connection is
successful.
Turn Wi-Fi On or Off
(Home) > Settings > Wireless & networks > Wired or
Wi-Fi > Wi-Fi On/Off
Wired Connection
What You Need
To connect the TV to the Internet, you need a
network router with a connection to the Internet. Use a
high-speed (broadband) connection to the Internet.
Make the Connection
(Home) > Settings > Wireless & networks > Wired or
Wi-Fi > Connect to network > Wired
1 - Connect the router to the TV with a network cable
(Ethernet cable**).
2 - Make sure that the router is switched on.
3 - The TV constantly searches for the network
connection.
4 - A message will be shown when the connection is
successful.
If the connection fails, you can check the DHCP setting of
the router. DHCP should be switched on.
**To fulfill EMC regulations, use a shielded FTP Cat. 5E
Ethernet cable.
13.3. Wireless and Network
Settings
View Network Settings
(Home) > Settings > Wireless & networks > Wired or
Wi-Fi > View network settings
You can view all current network settings here. The IP
and MAC address, signal strength, speed, encryption
method, etc.
Network Configuration - Static IP
(Home) > Settings > Wireless & networks > Wired or
Wi-Fi > Network Configuration > Static IP
If you are an advanced user and want to install your
44
To Next Page
Loading...
Need help?
General
