EasyManuals Logo
Home>Philips>Car Receiver>CED2000

Philips CED2000 User Manual

Philips CED2000
46 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
12 EN
Mount into the dashboard
Note
Make sure that wires are correctly connected before
you mount the main unit into a car.
If preset radio stations are lost when the ignition key
is turned OFF and then back ON, reconnect the red
leads crosswise to the yellow ones.
1 If the car does not have an on-board drive
or navigation computer, disconnect the
negative terminal of the car battery.
If you disconnect the car battery in
a car that has an on-board drive or
navigation computer, the computer
may lose its memory.
If the car battery is not disconnected,
to avoid short-circuit, make sure that
bare wires do not touch each other.
2 Make sure that the car dashboard opening
is within these measurements:
Since the unit cannot be used if the
dashboard opening's slant angle is
above 20 degrees, make sure that the
horizontal slant of the car dashboard
opening is between 0 and 20 degrees.
182 mm
112 mm
5 mm
3 Slide the unit into the dashboard until a
click sound is heard.
4 Reconnect the negative terminal of the car
battery.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Philips CED2000 and is the answer not in the manual?

Philips CED2000 Specifications

General IconGeneral
BrandPhilips
ModelCED2000
CategoryCar Receiver
LanguageEnglish

Related product manuals