EasyManuals Logo
Home>Philips>Car Receiver>CED2000

Philips CED2000 User Manual

Philips CED2000
46 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #44 background imageLoading...
Page #44 background image
42 EN
16 Troubleshooting
Warning
Never remove the casing of this product.
To keep the warranty valid, never try to repair
the product yourself.
If you encounter problems when using this
product, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips Web page (www.
philips.com/support). When you contact Philips,
make sure that the product is nearby and the
model number and serial number are available.
General
No power
Car engine has not been started. Start the
car engine.
Connections are incorrect.
The fuse has been damaged. Replace the
fuse.
No sound
Volume is too low. adjust the volume.
Speaker connections are incorrect.
No response to the remote control
Make sure that the path between the
remote control and the unit is clear from
obstacles.
Move the remote control close to the unit,
and point it at the iR sensor.
Press to switch to the control interface
for front source or rear source.
The function is not applicable to the
current media.
Replace the remote control battery.
The disc does not play.
The disc is upside down. Make sure that
the printed side is upwards.
The disc is dirty. Clean the disc with a
clean, soft, lint-free cloth. Wipe the disc
outwards from the center.
The disc is defective. Try another disc.
The disc is incompatible. Try another disc.
The recordable disc is not nalized.
The region code of DVD disc is not
supported. Use a disc with proper region
code.
Cannot play DivX le from an SD/SDHC card
or USB storage device
DivX DRM protected les cannot be
played if they are saved on an SD/SDHC
card or USB storage device. Transfer it to a
compatible disc instead.
No image
Parking wire connection is incorrect. Check
the wiring.
No image on rear monitor
Enable the signal transferring to rear
monitors (see 'Use rear monitors' on page
43).
A DivX video can be played for front
passengers only.
Image ashes or is distorted.
Video connection is improper. Check the
connections.
Noise in broadcasts
Signals are too weak. Select another station
with stronger signals.
Check the connection of the car antenna.
Preset stations are lost.
Battery cable is not correctly connected.
Connect the battery cable to the terminal
that is always live.
The fuse is broken.
The fuse type is incorrect. Replace it with
a 15 A fuse.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Philips CED2000 and is the answer not in the manual?

Philips CED2000 Specifications

General IconGeneral
BrandPhilips
ModelCED2000
CategoryCar Receiver
LanguageEnglish

Related product manuals