Aroma plus
Hot water
Steam
Espresso
Memo Memo Memo
Calc
clean
Espresso lungo Coee
8 Let the machine dispense the descaling solution until the no water light
lights up continuously.
9 Remove the water tank and rinse it. Fill the water tank with fresh water up
to the MAX level indication and place it back in the machine.
10 Empty the drip tray and container and place it back.
11 The rinse cycle light lights up continuously. When the ESPRESSO button
flashes, press it to start the rinsing cycle.
12 When the rinsing cycle is finished the CALC CLEAN button goes out.
13 The machine is heating up and performs an automatic rinsing cycle. The
ESPRESSO and COFFEE buttons flash simultaneously. The descaling
cycle is finished.
Caution: If the no water lights up continuously and the rinse cycle light
does not go out, the water tank was not filled up to the MAX level for the
rinsing cycle.Fill the water tank with fresh water and repeat the process
from step 10.
14 Remove the drip tray, rinse it and place it back. Empty the container.
15 Reinstall the Intenza+ water filter (if present).
16 Remove the water tank and rinse it.
17 Reattach the classic milk frother.
18 Clean the brew group by performing the 'Weekly brew group cleaning'
cycle.
The machine is ready for use.
Interruption of the descaling cycle
Once the descaling procedure has started, complete it until the very end
without switching off the machine. If the machine gets stuck during the
cycle, you can exit the descaling procedure by pressing the ON/OFF button.
If this occurs, or in case of a power failure or accidental disconnection of the
cord, perform the following steps:
1 Remove the water tank rinse it and fill it with fresh water up to the MAX
level.
2 Make sure the main switch is set to the ON position.
3 Press the ON/OFF button to switch on the machine.
4 Wait until the ESPRESSO, COFFEE, HOT WATER/STEAM buttons light up
continuously.
5 Empty the drip tray and place it back.
6 Empty the container and place it back.
7 Press the HOT WATER/STEAM button to dispense water. Press the same
button to stop the water dispensing.
8 Empty the container.
9 Place the container under the coffee dispensing spout.
10 Press the COFFEE button.
11 Repeat steps 9-10.
12 Empty the container.
If the CALC CLEAN button light remains on, you have to perform another
descaling cycle as soon as possible.
The machine is ready for use.
23
English
To Next Page
Loading...
Need help?
General
