Philips SimplyGo User Manual

10
SimplyGo User Manual
Inserting and Removing the Batteries
Your SimplyGo device comes with one rechargeable lithium ion battery� To
insert it correctly, follow these steps�
1� Place your device in a well ventilated location and make sure it is
turnedo.
Note: The SimplyGo device is shipped from the factory with the battery
removed�
Caution: OnlyremovethebatterywhentheSimplyGoisturnedo.
Never remove the battery while the device is
operating�
2� To remove the battery, insert your ngers into
the opening in the battery handle� Steadily pull
upward on the handle until the battery is released
from the enclosure� Continue to lift the battery
until it is entirely removed from the battery
compartment� If the device has been operating,
the surfaces may be warm to the touch� This is
normal�
3� Check the battery gauge (shown below)� To do so, press the white
button (shown below) on the battery and watch how many LEDs
light up� If the batteries are low, you can recharge them� See the
Charging the Battery with AC Power Supply section�
No. of LEDs Battery Charge
4 LEDs Light:
75% to 100% full
3 LEDs Light:
50% to 75% full
2 LEDs Light:
25% to 50% full
1 LED Lights:
10% to 25% full
1 LED Blinks
3 Times:
Battery is less than
10% full and
needs to be
recharged

Philips SimplyGo Specifications

General

Brand	Philips
Model	SimplyGo
Category	Oxygen Equipment
Language	English