To Next Page

To Previous Page

SimplyGo User Manual

Operating the SimplyGo Device

Power Options

Warning: Do not use the device without the battery installed and operating�

• Torunthedeviceonbatterypower,makesurethebatteryisproperly

inserted and suciently charged� (The battery should be fully

charged the rst time you use it�)

• To run the device using AC power, rst make sure you have a

battery installed� Then, follow these steps:

1� Connect the output cable of the AC Power Supply to the

SimplyGo power input connector�

2� Connect the AC Power Cord’s connector into the AC power

supply�

3� Connect the AC Power Cord’s plug into an AC outlet installed to

meet national or regional electrical code�

Note: The AC Power Supply is equipped with a green light, which illuminates

when it is connected to an energized AC power source�

• To run the device using DC power from an automobile or other

motorized vehicle, make sure the battery is installed� Start the vehicle

and connect one end of the DC Power Cord to the device’s power

inlet and the other end into the vehicle’s DC electrical outlet�

Because the amount of current available in the vehicle electrical

system is limited, the current available to charge the SimplyGo

battery will be determined by the operating mode of the device� At

high settings the time required to charge the battery will be much

longer and at the highest settings, it may not charge at all�

Philips SimplyGo User Manual

Other manuals for Philips SimplyGo