Recommended products
AGIP FILTER OIL
Oil for air filter sponge
Mineral oil with specific additives for increased adhesiveness
03_13
03_14
Cooling fluid level (03_13, 03_14, 03_15, 03_16)
Engine is cooled by a forced-circulation coolant system. The cooling circuit holds ap-
prox. 2 litres of coolant consisting of a mixture of 50% de-ionised water and 50% glycol
ethylene-based antifreeze solution with corrosion inhibitors.
The coolant supplied with the scooter is already mixed and ready for use.
For proper functioning of the engine, ensure that the temperature of the coolant is
always within the middle zone of the gauge «E». If the needle of the gauge enters the
red zone, stop the engine, let it cool down and check the coolant level; if the level is
OK, contact an Authorised Service Centre.
Check coolant when the engine is cold as indicated in the scheduled maintenance
tables, following the steps below:
1. Rest the scooter upright on the stand: remove the cover by taking out the screw
«A».
2. Remove the expansion tank cover «B» by turning it anticlockwise.
3. Look inside the expansion tank and check that the reference tongue «C» is covered.
4. Top-up the expansion tank if the coolant level does not reach the reference tongue
«C».
If the level is not correct, proceed to top-up when the engine is cold. If the coolant
needs to be topped up frequently or the expansion tank is completely dry, check the
cooling system for the cause of the problem. It is therefore essential to have the cooling
system checked at an Authorised Service Centre.
Replace coolant as indicated in the scheduled maintenance table. Take your vehicle
to an Authorised Service Centre for this operation.
45
To Next Page
Loading...
Need help?
General