A certain lowering of the level is caused by wear on the pads. Should the level appear
to be below the minimum mark, please contact an Authorised Service Centre or
Dealer in order to have a thorough inspection of the braking system carried out.
03_18
03_19
Braking system fluid top up (03_18, 03_19, 03_20, 03_21, 03_22,
03_23, 03_24, 03_25, 03_26)
Proceed as follows:
1. Remove the windshield by undoing the four screws indicated.
2. Remove both inspection covers «A».
3. Unscrew the two screws «B» (one per side).
4. Unscrew the five screws «C».
5. Remove the right and left control units.
6. Unscrew the two screws «D» and remove the front handlebar cover (one per side).
7. Remove the rear-view mirrors by unscrewing the nut «E».
8. Unscrew the four screws «F» (two per side).
9. Remove the reservoir cover «G» by loosening the two fixing screws and refill with
the prescribed brake fluid type only and without exceeding the maximum level.
Under standard climatic conditions, replace coolant as indicated in the scheduled
maintenance table. This operation must be carried out by trained technicians; take
your scooter to an authorised Service Centre or Dealer.
WARNING
ONLY USE DOT 4 CLASS BRAKE FLUIDS. COOLING SYSTEM FLUIDS ARE
HIGHLY CORROSIVE. MAKE SURE THAT IT DOES NOT COME INTO CONTACT
WITH THE PAINTWORK
.
47
To Next Page
Loading...
Need help?
General