Pioneer BDP-150 User Manual

01
12
En
Note
•To operate an AV receiver equipped with a remote
control mode setting using the RECEIVER CONTROL
buttons, set the AV receiver’s remote control mode to
“1”. For details, see the AV receiver’s operating
instructions.
Front Panel
1  STANDBY/ON – Press to turn the power on and
off.
2 Disc tray
3 Front panel display
4 Reset button – If the power cannot be turned off (set
to standby), use a thin rod to press this button. The
unit restarts, at which point it is again operable.
5 Remote control sensor – Point the remote control to
this, then operate it within approximately 7 m.
The player may have trouble capturing remote control
signals if there is a fluorescent light nearby. If this
happens, move the player away from the fluorescent
light.
6  OPEN/CLOSE – Press to open and close the disc
tray.
7  – Press to stop playback.
8 USB port – (page 16)
9  – Press to start playback.
Rear Panel
1 DIGITAL OUT (COAXIAL) terminal – (page 16)
2 VIDEO OUT terminal – (page 16)
3 AUDIO OUT terminals – (page 16)
4 HDMI OUT terminal – (page 13)
5 LAN (10/100) terminal – (page 17)
6 USB port – (page 16)
7AC IN – (page 18)
1 2 3 54 6 7 8
9
321 5 6 74
BDP-150_VXE8_IBD_EN.book 12 ページ ２０１２年３月１２日 月曜日 午後４時１０分

Pioneer BDP-150 Specifications

Power

power requirements	110-240 V 50/60 Hz
power consumption	20 W
power consumption during standby	0.3 W

Weight and Dimensions

dimensions	17-1/8 x 2-5/16 x 9-13/16 inches
weight	4 lbs. 10 oz.