Pioneer CT-W403R User Manual

TROUBLESHOOTING
Symptom
Remedy
POOR SOUND QUALITY
@ Clean {see page 4).
|
OTHERS
The music search function
does not work.
Unstable or interrupted @ The head, pinch rollers and capstans are dirty.
sound e The tape is not uniformly wound. ® Compietely fast-forward or rewind the tape.
No high frequencies ® A tape recorded without Dolby NR is being }¢ Set DOLBY NR switch to OFF.
|
played
back
with
DOLBY
NR
switch
in
the
Bor
C
|
i position.
® The head is dirty. @ Clean the head {see page 4).
High frequencies are | © A Dolby NR-encoded tape is being played back @ Set DOLBY NR switch to the same position used |
emphasized. with DOLBY NR switch in the OFF position. for recording.
Sound from previous @ The head is dirty. le Clean the head (see page 4).
recordings remains when
rerecording a tape.
The sound is distorted. @ Recording level is too high. | © Turn REC LEVEL control down when recording
{
(see
page
13).
© The recorded signal itself is distorted. ® Replace the cassette.
@ The head is dirty. \-® Clean the head (see page 4), |
Too much noise i © High noise tape is being used. ®@ Replace the cassette.
@ Incomplete insertion of a connection cord, poor ® Check connections (see page 6).
contact.
@ Recording level is too low. ® Turn REC LEVEL contro! up when recording (see
i
page
13).
@ The head is dirty. @ Clean the head (see page 4),
@ The head is magnetized. ® Demagnetize with a head demagnetizer.
a ee a LR ee i NE 2 en) ee ee ee ee Ae ee a
Ltt
@ Blanks between selections are less than 4
seconds long.
® Use a tape with blanks more than 4 seconds
long.
@ Connect the control cord (see page 6).
(CT-W503R only)
Cannot use the remote @ The contro! cord is not connected.
control system,
1
CD - DECK SYNCHRO is @ The components are not connected properly. ® Connect them properly (see page 6). .
disabled. (CT-W503R only) | @ The cassette erasure prevention tabs are broken. | @ Replace the cassette with one whose tabs-are
| intact.
{
The CD SYNC indicator is | @ The tape ran out during the CD - DECK SYNCHRO | ® Replace the tape with a longer one. |
off during CD - DECK mode.
SYNCHRO recording. @ After the deck entered recording standby mode, @ Change the disc and press the CD SYNC button
more than 1 minute elapsed before the CD player
resumed playback.
again.
POWER-CORD CAUTION
Handle the power cord by the plug. Do not pull out the plug by
tugging the cord and never touch the power cord when your
hands are wet as this could cause a short circuit or electric shock.
Do not piace the unit, a piece of furniture, etc., on the power cord,
or pinch the cord. Never make a knot in the cord or tie it with other
cords. The power cords should be routed in such a way that they
are not likely to be stepped on. A damaged power cord can cause
fire or give you an electrical shock. Check the power cord regu-
lary. When you find it damaged, ask your nearest PIONEER auth-
orized service center or your dealer for a replacement.
AT
<RRBIT42>
En

Pioneer CT-W403R Specifications

General

Brand	Pioneer
Model	CT-W403R
Category	Cassette Player
Language	English