Using the tuner
07
43
En
Naming station presets
For easier identification, you can name your
station presets.
1 Choose the station preset you want to
name.
See Listening to station presets (this page) for
how to do this.
2 If you’re using the remote control,
press RECEIVER (VSX-D412 only).
3 Press TUNER EDIT (T. EDIT on the VSX-
D512 remote).
The display shows ST. NAME, then a blinking
cursor at the first character position.
4 Input the name you want.
Names can be up to four characters long.
• Use the front panel MULTI JOG/INPUT
SELECTOR dial or the remote control } ]
buttons to select characters.
• Press ENTER to confirm a character. If no
character is input, a space is input.
• The name is stored when ENTER is
pressed after choosing the fourth character.
To erase a station name, simply repeat steps
1-3 and input four spaces instead of a name.
Once you have named a station preset, you
can press DISPLAY when listening to a
station to switch the display between the
name and the frequency.
Listening to station presets
Having stored up to 30 stations (see previous
page), preset stations can be easily recalled.
1 Press the TUNER button on the remote
control to select the tuner.
2 Press CLASS to select the class in which
the station is stored.
Press repeatedly to cycle through classes A, B
and C.
3 Press STATION +/– (ST +/– on the VSX-
D512 remote) to select the station preset
you want.
• If the receiver is left disconnected from the
AC power outlet for an extended period, the
station memories will be lost and will have to
be reprogrammed.
To Next Page
Loading...
Need help?
General