107
MAINTENANCE AND LUBRICATION
Battery
Battery Removal
1. Disconnect the hold-down strap holding the battery in position, and
remove battery cover.
2. On conventional batteries, remove the battery vent tube.
3. Disconnect the black (negative) battery cable first.
4. Disconnect the red (positive) battery cable next.
5. Lift the battery out of the ATV. Be careful not to tip a conventional
battery sideways, which could spill electrolyte.
Battery Installation
1. Set the battery in the battery holder.
2. With conventional batteries, install the battery vent tube (sealed
batteries do not have a vent tube). NOTE: The vent tube must be
free of obstructions and securely installed. If not, battery gases
could accumulate and cause an explosion. The tube should be
routed away from the frame and body to prevent corrosion. Avoid
skin contact with electrolyte, which can cause severe burns.
3. First connect and tighten the red (positive) cable.
4. Second connect and tighten the black (negative) cable.
5. Reinstall the battery cover and attach the hold-down strap.
6. Verify that cables are properly routed.
NOTE: When installing a new battery, make sure it’s fully charged
prior to its initial use. Using a new battery that has not been fully
charged can damage the battery and result in a shorter life. It can also
hinder vehicle performance.
If electrolyte spills, immediately wash it off with a solution of one
tablespoon baking soda and one cup water to prevent damage to
the vehicle.
CAUTION
To Next Page
Loading...
Need help?
General
