EasyManuals Logo
Home>Polaris>Utility Vehicle>2013 Ranger EV

Polaris 2013 Ranger EV User Manual

Polaris 2013 Ranger EV
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #55 background imageLoading...
Page #55 background image
51
MAINTENANCE
Batteries
Battery Access
To access the batteries, remove the seat. See page 27. Remove the storage tray (if equipped).
NOTICE: Before removing the seat to access the batteries, make sure any wire or metal items
(including seat belt latches) remain clear of the battery compartment to avoid causing a
short circuit to the electrical system.
Battery Inspections
Inspect battery terminal connections monthly. Clean batteries as recommended. Using an
insulated wrench, torque bolts to 8 ft. lbs. (11 Nm).
Battery Cleaning
Always keep battery terminals and connections free of corrosion. To clean, remove corrosion
with a stiff wire brush. Wash with a solution of one tablespoon baking soda and one cup
water. Rinse well with tap water and dry off with clean shop towels. Coat battery terminals
with dielectric grease or petroleum jelly.
NOTICE: Do not allow cleaning solution or tap water to enter the batteries.
Battery Replacement
With proper care and maintenance as outlined in this owner’s manual, battery life could be
extended up to four years or longer, depending on the amount of use. When battery replace-
ment is necessary, please see your authorized POLARIS dealer.
WARNING! Handling batteries and electrical components improperly can result in serious injury or
death. Do not attempt to remove batteries or battery cables. Always see your dealer for battery-related
service.
Battery Fluid
A poorly maintained battery will deteriorate rapidly. Check the battery fluid level often. Add
only distilled water. Tap water contains minerals that are harmful to a battery.
Unless the plates are exposed before charging, distilled water should be added to a battery
after charging. If the plates are exposed, add water to about 1/8 inch (3 mm) above the plates,
then charge. Check the fluid level again after charging. Maintain the fluid level 1/4 inch (6
mm) below the bottom of the fill well in the cell cover. Do not overfill.
Cell Covers
Plates
1/4ā€ (6 mm)
Fill
Well

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Polaris 2013 Ranger EV and is the answer not in the manual?

Polaris 2013 Ranger EV Specifications

General IconGeneral
BrandPolaris
Model2013 Ranger EV
CategoryUtility Vehicle
LanguageEnglish

Related product manuals