ADJUSTABLE HEADLIGHT
NOTICE
The image below is for reference only. Your model may differ slightly.
HEADLIGHT INSPECTION
It is very crucial to correctly complete the steps below in order to achieve optimal
headlight performance. The headlight can be inspected for vertical aim using the
following procedure.
1. In a well-ventilated area, position the snowmobile on a level surface with the
headlight approximately 25 ft (7.6 m) from a wall
q
.
2. Place the rider or the approximate weight of the rider on the seat or tunnel
floorboards.
3. Measure the distance from the floor to the center of the headlight and make a
mark on the wall at the same height
w
.
4. Start the engine. Move the headlight switch to low beam.
5. Observe the headlight aim on the wall. There should be a distinct horizontal
line on the wall from the low beam. That line should align with the mark on
the wall
w
.
36
FEATURES
To Next Page
Loading...
Need help?
General
