1. Do not stop the engine.
2. Press and hold the center
button on the instrument cluster to enter the
Options Menu.
3. Press and release the MODE button until DIAGCODE appears in the
information display area. The Diagnostic display mode will appear in the
Options Menu if there is an active trouble code.
TIP
When the diagnostic mode is displayed, the check engine warning indicator will
begin to flash.
4. A set of two numbers will appear in the display.
• The 2-6 digit suspect parameter number (SPN) in the information display
area indicates which component is generating the fault code.
• The 1-2 digit failure mode indicator (FMI) number in the odometer area
indicates the fault mode, such as open or short circuit.
5. More than one fault may be active. Press and hold the SET button or SET
switch for two seconds to toggle to the next active code. Repeat until all
codes are retrieved.
6. See Diagnostic Trouble Codes for code definitions and failure descriptions.
FUEL TYPE SELECTION
When using the recommended 91
non-ethanol gasoline, always select the
91 NON-ETHANOL setting. When using
ethanol, MTBE, or other forms of
oxygenated gasoline, the fuel type must
be changed to
NON-PREMIUM/ETHANOL in the
gauge.
IMPORTANT
Whenever in doubt of your fuel purchase, use the NON-PREMIUM / ETHANOL
mode.
Use the following procedure to change the fuel type designation in the gauge.
Refer to the fuel type selection label located inside the left side panel.
62
GAUGE
To Next Page
Loading...
Need help?
General
