Page 19
ENG
P825
3.6 P825 Motor Block Test
Brancher la diag box
Connecter le bloc moteur à la diag
box avec l’adaptateur marron
Appuyer sur
« Cleaner » puis
« Start/Stop »
Test
Dia6
Moteur traction
marche avant
Moteur traction
marche arrière
Démarrage du
moteur pompe
Arrêt du moteur
pompe
TEST
SC
Changer le
bloc moteur
OK
TEST
Changer la
diagbox
Fail- aT
Débrancher/
rebrancher la
diagbox
Appuyer sur
« Cleaner » puis
« Start/Stop »
Fail- aT
TEST
OK
*
TEST
Fail- Com
Débrancher/
rebrancher l’ensemble
bloc moteur/diagbox
Appuyer sur
« Cleaner » puis
« Start/Stop »
Changer le
bloc moteur
Fail- Com
OK
TEST
OK
OK
Test rotation
droite
Test rotation
gauche
Fail- trac
Changer le bloc
moteur
Fail- pump
Changer le bloc
moteur
Fail- At
*
Se reporter à la description du
défaut en haut du logigramme
TEST
Fin
OK
Tfd
Tbd
tcl
tcc
Pon
Poff
End
Appuyer sur
« Start/stop » ou
« OK » ou
« Cancel »
Famille Vortex uniquement
*
*
***
SC
Fail- Com
*
Se reporter à la description du
défaut en haut du logigramme
***
Se reporter à la description du
défaut en haut du logigramme
SC
Fail- Com
*
Se reporter à la description du
défaut en haut du logigramme
***
Se reporter à la description du
défaut en haut du logigramme
*
1. Plug in Diagnostic Box
2. Connect the Motor Block to the Diagnostic
Box using the BROWN test cable.
Disconnect /
Reconnect
Diag Box
Press
[CLEANER]
then Start/Stop
Replace the
Motor Block
Press
[CLEANER]
Press
[CLEANER]
then Start/Stop
END
Press Start/
Stop or [OK] or
[CANCEL]
Disconnect /
Reconnect Motor
Block and Diag Box
Replace the
Diag Box
Replace the
Motor Block
Forward
Traction Motor
Backward
Traction Motor
Testing Clockwise
Rotation
Start Pump
Motor Test
Replace the
Motor Block
Testing Counter
Clockwise
Rotation
Stop Pump
Motor Test
Replace the
Motor Block
See explanation for
same error message above.
See explanation for
same error message
above.
See explanation for
same error message above.
See explanation for
same error message above.
See explanation for
same error message above.
SERIES 93 94 95 only