Polaris 93 Series User Manual

Page 9
ENG
93 94 95 SERIES
Remove the Floating Cable
7. Connect one end of the BROWN test cable
into the motor block.
8. Connect the other end of the BROWN test
cable into the Diagnostic Box.
9. On the Diagnostic Box, press [CLEANER]
button then Start/Stop button to begin the test.
The drive gears will rotate on the drive shaft
for approximately ten (10) seconds then stop.
The Diagnostic Box displays the test status
and progress message (see Section 1.7).
10. If the cycle completes and the Diagnostic Box
displays the message: End, the Motor Block
is functional and the Floating Cable should be
replaced.
11. If there is an error message on the Diagnostic
Box display, see Section 2.6 Motor Block
Test for explanation and action.
12. If the test results in a Fail error message,
replace with a new motor block.
NOTE Return all defective component(s) to
Polaris. (For more information, go to
www.Polarispool.com.)

Polaris 93 Series Specifications

General

Brand	Polaris
Model	93 Series
Category	Vacuum Cleaner
Language	English