106
MAINTENANCE AND LUBRICATION
Oil an d Filter Change
1. Place the vehicle on a level surface.
2. Clean the area around the oil tank (1) and
crankcase (2) drain plugs with clean shop
towels.
3. Run the engine for two to three minutes until
warm, then stop the engine.
4. Place a drain pan beneath t he oil tank and
remove the drain plug.
CAUTION
Hot oil can cause serious burns to skin. Do not allow hot oil to contact skin.
5. Allow the oil to drain completely.
6. Replace the sealing washer and reinstall the plug. Torque to 14 ft. lbs. (19 Nm).
NOTE: The sealing surfaces on drain plugs, oil tank and crankcase should be clean and
free of burrs, nicks or scratches.
1
2
To Next Page
Loading...
Need help?
General
