Polaris Alpha iQ+ User Manual

Page 10
English
Install and Submerge the Cleaner
1. With the control box plugged into a GFCI
outlet, spread the oating cable across the
pool deck until you reach the middle of the
pool length.
2. At the center point, submerge the cleaner in
the pool and hold in the vertical position to
release any air trapped inside. (Figure 12).
1
Figure 12. Submerge the Cleaner Vertically
NOTE: For optimal patterning and reduced tangling, the floating cable should enter the water near the middle of the pool
length. Only place enough cable in the water to reach the farthest point in the pool (see Figure 14).
Max
Floating Cable
Length
caddy /
control unit
cleaner
cleaner
Recommended
entry point
Not
Recommended
WARNING: Do not use
an extension cord
Figure 14. Pool Entry Point for Optimal Patterning
3. Ensure the unit sinks to the bottom of the
pool and does not oat
(Figure 13).
2
Figure 13. Cleaner Sinking to the Bottom of the
Pool
4. Place only enough oating cable in the
water to reach the farthest end of your
pool from the central point. Spread out the
oating cable ensuring there are no kinks
or coils in the cable (Figure 14).

Polaris Alpha iQ+ Specifications

General

Brand	Polaris
Model	Alpha iQ+
Category	Swimming Pool Vacuum
Language	English