53
OPERATION
Starting the Engine
Starting a Cold Engine
WARNING
Engine exhaust contains poisonous carbon monoxide and can
cause loss of consciousness resulting in severe injury or death.
Never run an engine in an enclosed area.
CAUTION
Operating the vehicle immediately after starting could cause
engine damage. Allow the engine to warm up for several minutes
before operating the vehicle.
1. Place the t ransmission in park and
lock the parking brake.
2. Turn the fuel tank valve on.
3. Sit on the vehicle.
4. Pull the choke knob out until it
stops (1).
NOTE: The variable choke is fully on
when the knob is pulled
completely out. The choke is off when
the knob is pushed completely in. The choke can be
adjusted gradually, depending on how much choke is needed
for starting. Be sure the choke is off during operation, as
excess fuel washing into the engine oil will increase wear on
engine components.
5. Turn the engine stop switch to RUN.
NOTE: Do not press the throttle while starting the engine.
6. Turn the ignition key past the ON position to engage the starter.
Activat e the starter for a m aximum of five seconds, releasing the
key when the vehicle start s. If the engine does not start, release the
starter and wait five seconds. Then activate the starter for another
five seconds. Repeat this procedure until the engine starts.
7. If the engine slows or stops, position the choke knob half way in to
allow proper engine warm up.
8. Vary the engine RPM slightly with the throttle to aid in warm-up.
When the engine idles smoothly, push the choke all the way in.
1
To Next Page
Loading...
Need help?
General
