32
The roller has a separate electric drive which is turned on simultaneously with the vacuum cleaner motor.
To clean the roller:
1. Turn off the device with the I/O switch (put it in the O position).
2. Turn the vacuum cleaner upside down and place it with the back toward you.
3. At a small amount of hair and threads wound around the bristle roller, they can be cut with a knife without
removing the bristle roller.
To do this, place a sharp knife between the rows of bristles with the cutting edge
outward from the roller, and cutting along the roller cut the coiled hair and threads. After this, the hair cuts are
easily removed outward from the brush body, for convenience, it is allowed to rotate the bristle roller around the
axis of its rotation manually.
4. In case of severe clogging of the bristle roller, remove the frame for attaching
the electric brush roller for
which slightly press the tabs of the latches of the latch away from you and raise the near edge of the frame, and
then remove the frame.
5. Lift the right side of the bristle roller by pulling to the right, disengage it from the drive and remove it
from the socket. When the bristle roller is removed from the body, it can be easily cleaned of coiled hair and
threads with a sharp knife or
scissors.
6. Put the bristle roller into place in the brush body in the reverse order.
7. In case of severe clogging of the brush and the drive parts, contact an authorized service centre for
disassembly and cleaning.
The works related to cleaning the vacuum cleaner components are not included in the warranty service.
TROUBLESHOOTING
This table lists the most common problems that may occur when using the device. Depe
nding on the cause of
the malfunction you will hear the sound signals from 1 to 4. If you can’t cope with the problems yourself contact
the customer support centre or an authorized service centre.
The wheel/wheels do not spin
Check the wheels. Make the cleaning if
necessary.
Problem with infrared sensors
or bumper sensors
Clean the infrared sensors, move the bumper
slightly and check for a foreign object
between the objects
Release the device housing and restart it.
The main electric brush does
not rotate
Clean the main electric brush
Attention! If you cannot resolve the problem on your own using the steps described above, please contact your
POLARIS Authorized Service Center.
.
..
...
....
To Next Page
Loading...
Need help?
General
