8
Chapter 1 Introducing the LCD TV
Do not use caustic cleaners (porcelain, stainless steel, toilet, or oven cleaner
etc.) on the remote, as it may suffer damage.
Use an antenna cable to connect the VHF/UHF signal to the LCD TV’s ANT. terminal (refer
to page 15-18).
Connect the AC power cord at the back of the TV and connect the power cord to wall outlet.
Insert the 2 batteries supplied in remote control.
Connect another external AV device (refer to page 19-25).
Step1 Slide the back cover up to open the
battery compartment of the remote
control.
Step2 Insert two AAA size batteries.
Make sure to match the (+) and
( - ) ends of the batteries with
the (+) and ( - ) ends indicated
in the battery compartment.
Slide the cover back into place.
How to setup the TV
IMPORTANT: When replacing your used batteries, it is your responsibility as a
consumer to ensure the batteries are disposed of properly. To fi nd out how to
properly dispose of the batteries, please go to www.polaroid.com and click on
“Company“ or call the customer service number for your country listed in the
instruction manual.
To Next Page
Loading...
Need help?
General
