How To Manually Provision a Poly CCX phone
Objective
Manual provisioning of a Poly CCX series phones for the 8x8 Work service.
Applies To
• 8x8 Work
• Poly CCX model phones
Procedure
While provisioning of these phones can be done from the phone's physical interface, it's much easier to perform these
steps from the phone's web browser user interface (GUI).
Note: If you need to reset your Poly CCX phone to its factory default settings, follow the steps in the Restore Factory
Default Settings section first, and then provision your phone.
Provisioning
First you'll need to obtain the local (internal network) IP address of your phone:
1. Connect the phone to your local network and power it up.
2. Once the phone boots up, press the following: Settings (gear) > Status > Network > TCP/IP Parameters.
3. Locate and note the IPv4 Addr. You will need this IP address to configure the 8x8 Provisioning Server.
Next, you'll configure your provisioning parameters:
4. In your computer's web browser (on the same local network as your phone), enter the following line into the
browser Address bar, using the IP address of the phone:
◦ https://[IP ADDRESS]
◦ Example: https://192.168.0.10
5. In the Poly Web Configuration Utility login page:
a. Select Login As: Admin
https://support.8x8.com/equipment-devices/phones/polycom/How_To_Manually_Provision_a_Poly_CCX_phone
Updated: Sat, 27 Aug 2022 04:29:10 GMT
Powered by
1
To Next Page
Need help?
General
