factory default login details are username: admin and password: admin.
Go to Status in left navigation menu.
■
Click on System Status.
■
Under Product Information section you can see Software Version field that contains
■
information about firmware version.
DHCP server
Fully configured and operational DHCP server.
PBXware version
PBXware version 6.6.1
In order to find out the PBXware version:
Login to PBXware
■
Navigate to Settings: About.
■
On the top of About page is a code similar to this one PBXware Edition: Business, Release:
6.6.1. (387597b7), Running: 16.16.1-gc-c0d40968, PBXware Proxy v6.6.1 (7009484),
API: 6, libmemcached version: 1.0.18, where Release denotes the exact version of your
PBXware.
Installation
This chapter describes how to install and connect the phone to the electrical power and data
network as well as how to apply factory settings.
The following topics are covered:
Power adapter
■
Power over Ethernet (PoE)
■
Factory Settings
■
Power adapter
Connect the Network and Power
Connect the DC plug on the power adapter to the DC port on the phone and connect the other
■
end of the power adapter into an electrical power outlet.
Connect the ethernet cable between the Internet port on the phone and the network port on a
■
router or switch to access LAN.
NOTE: If you are using Power over Ethernet (PoE), you don't need to connect the AC adapter.
Make sure the Ethernet cable and router or switch is Power over Ethernet (PoE) compliant.
To Next Page
Loading...
Need help?
General
