▪ Navigate to System Management -> Device Maintenance -> Reset Configuration -> Reset
The base unit should now reboot. From this point, you can perform the provisioning steps documented above.
Additional Information
Known Poly limitations on Poly Rove B2:
• Maximum of 5 concurrent calls when G722 codec is used on all calls.
• Maximum of 4 concurrent calls when G729a codec is used on all calls.
• When G722 codec is enabled on the base, even if all calls negotiate to G711 codec, the maximum number of calls
is 9.
• SRTP cannot be enabled on this device in Admin Console. If this feature is required, please reach out to our
support team who can enable it.
• Poly does not yet support SIP Publishes on Rove devices, so no quality metrics will be available in ‘Analytics for
8x8 Work.
https://support.8x8.com/equipment-devices/phones/poly/Poly_Rove_Manual_Provisioning
Updated: Mon, 03 Oct 2022 19:31:49 GMT
Powered by
6
To Previous Page
Loading...
Need help?
General
