2
2
IMPORTANT SAFETY INSTRUCTIONS
When installing and using this electrical equipment, basic safety precautions should always be followed, including
the following:
1. READ AND FOLLOW ALL INSTRUCTIONS
2. WARNING - To reduce the risk of injury, do not permit children to use this product unless they are closely
supervised at all times by an adult who is capable of assisting a child in distress.
3. WARNING - Risk of electrical shock. Connect only to a grounded receptacle protected by a ground-fault cir-
cuit-interrupter (GFCI). A GFCI must be provided in accordance with Section 680-31 of the National Electrical
Code. Contact a qualified electrician if you cannot verify that the receptacle is protected by GFCI.
4. WARNING - To reduce the risk of electrical shock, replace damaged cord (with pump body) immediately.
NEVER bury cord. Locate cord to eliminate abuse or contact from lawn mowers, hedge trimmers, and other
equipment. NEVER use an extension cord to connect unit to electric supply; provide a properly located outlet.
5. CAUTION - The power filter is for use with storable pools only. DO NOT use with permanently installed
pools. A storable pool is constructed so that it may be readily disassembled for storage and reassembled to its
original integrity. A permanently installed pool is constructed in or on the ground or in a building so that it can-
not be readily disassembled for storage.
6. CAUTION - For continued protection against possible electric shock, use only original equipment manufac-
tured (OEM) parts for your replacement requirements.
7. SAVE THESE INSTRUCTIONS.
PRELIMINARY STEPS
1. READ ALL INSTRUCTIONS CAREFULLY and get a thorough understanding of what is required to
assemble your Type SFS Power Filter.
2. Before you begin to assemble the pool, identify, count, and check all parts needed for assembly. Refer to the
“PARTS LIST AND ACCESSORIES”, Page #9, under the quantity column for your size pool.
3. It is recommended that you have some PETROLEUM JELLY on hand for lubricating the gaskets
POWER FILTER
IMPORTANT NOTES:
1. Installer shall follow written instructions provided for operation of the circulation systems.
2. All electrical components shall be installed in accordance with Article 680 of the National Electrical Code
(NEC) “Swimming Pools, Fountains and Similar Installations” or its latest approved edition.
3. The Filter Cartridge (9) 3-3/4” will hold as many as 2 of the 1” diameter chlorine tablets and the 8” will hold
as many as 6 of the 1” diameter chlorine tablets. Check your chlorine levels to determine the proper number of
chlorine tablets to add. The filter cartridge will automatically dispense chlorine into the pool as the pump runs.
You must have the type of Filter Cartridge (9) with a central core mesh divider (See page 3) to use the
chlorine dispenser. DO NOT use this to dispense powdered chlorine, shock treatment or any other type of
chemicals as damage to the pump, filter cartridge, and pool will occur.
4. These Skimmer Filter Systems are manufactured by Dongguan Polyfilm Plastics Products Co. Ltd. and UL Listed
(file #E307476) - double insulated and grounded - 115 V.A.C. - 60 Hz. (Unit must have a minimum of 105
V.A.C. to start and run properly.) The units’ wattage and capacity is as follows:
SFS600 Filter System with F600C Pump 46 watts 0.8 amps 580 G.P.H.
SFS600 Filter System with F700C Pump 57 watts 1.1 amps 780 G.P.H.
SFS1000 Filter System with F700C Pump 57 watts 1.1 amps 780 G.P.H.
SFS1000 Filter System with F1000C Pump 80 watts 2.2 amps 1075 G.P.H.
SFS1000 Filter System with F1500C Pump 120 watts 2.0 amps 1500 G.P.H.
SFS2000 Filter System with F2000C Pump 210 watts 2.2 amps 2000 G.P.H.
To Next Page
Loading...
Need help?
General
