16
Note: The flow readout is intended as a reference only. If accurate flow readings are required
an external flow meter is recommended.
NOTE: Metric pressure reading output must be multiplied by 100 for kPa.
4.6 Selecting the Internal/External Temperature Display
NOTE: This section applies only when the ambient tracking probe or remote temperature control are
installed and enabled. It allows the user to check or continuously display either the Chiller’s internal
outlet fluid temperature or the external ambient/process temperature.
When the ambient tracking probe is selected (AtC) (see Section 4.7.8), the Chiller normally displays
the internal outlet fluid temperature. To display the external ambient temperature, press and release
the Units/Menu Select button until P2 appears on the pressure/flow rate display.
When the remote temperature control probe is selected (rPC) (see Section 4.7.8), the Chiller
normally displays the external process temperature. To display the internal outlet fluid temperature,
press and release the Units/Menu Select button until P1 appears on the pressure/flow rate display.
NOTE: P1 or P2 will remain on the pressure/flow rate display until the Units/Menu Select button is
pressed and released. The displayed temperature will revert to the default condition (internal
temperature for the ambient probe, external temperature for the remote temperature control probe).
To Next Page
Loading...
Need help?
General
