13
- If a monitoring system is available, connect the amplifier of the monitoring system to the RCA output
BOOTH.
5. For analogue sound recordings, connect a recording unit to the output REC. The recording level is
independent of the position of the outputs controls MASTER CONTROL, MASTER LEVEL and BOOTH
VOLUME.
6. Instead of the audio signal coming from the computer, the master outputs and the booth output can also
supply the signal of an external signal source with line level output (e.g. CD player). Use the stereo RCA
jacks LINE INPUT for connecting the unit.
7. By operating the controller with a computer and units grounded via the mains cable (e.g. amplifier), noise
interference may occur due to ground loops. To eliminate this interference, a ground isolator.
CONNECTING A COMPUTER
1. Set the power selector switch to the position USB for power supply via the USB connection of the
computer.
2. Use the supplied USB cable to connect the controller to an available USB port on your computer. As soon
as the controller is connected to a computer, it will be recognized as a generic USB audio device and the
required drivers are installed. The power indicator lights up red to indicate that the controller is receiving
power from the USB bus. The controller can be used in conjunction with your computer’s soundcard
without causing conflicts. You may connect and disconnect the controller at any time.
3. The controller is supplied with power via the USB connection of the computer. However, if the connection
should not supply sufficient power (e.g. when connected to a non-powered USD hub), use a 5V power unit
(not included): Connect the cable of the power unit to the power input DC in 5V/1A and the power unit to a
power outlet. Set the power selector switch to the position ADAPTOR. Use the unit only with a 5V/1A
adapter. Always disconnect the mains connector when you wish to change connections, move the unit to a
different place or if it is not used for a longer period.
4. After connecting, start the DJ software Virtual DJ LE. If the program has already been started prior to the
connection, it must be terminated and restarted, otherwise the controller cannot be operated.
CONFUGURATION OF THE CONTROLLER
To Next Page
Loading...
Need help?
General
