To Next Page

To Previous Page

ARTICULATED ARM OPENERS USER MANUAL

3.4 Function Settings

Note(F3 Setting is for F1-3 Motor with Hall sensor):

Only in “F1-3”Hall sensor mode, the PCB will record all the current value while learning mode. Please set F3 function

after learning mode. The LED display 10 to indicate all of the recorded values will increase 1 ampere as the over current

value. In other words, the LED shows 20 to indicate all the recorded values will increase 2 ampere as the over current

value. The value can be adjusted by pressing button UP and DOWN. The maximum value is 40(4.0A) and the minimum

value is 05(0.5A).

LED Display Definition Parameter Table Description

Motor Type

Dual or Single Gate

Over Current Setting

Operation Speed

Deceleration function

Deceleration Speed

Open/Close delay of dual

gate operation adjustment

Auto-Close adjustment

Photocell function mode

Pedestrian Mode function

Pre-Flashing function

F1-1

F1-2

F1-3

F2-1

F2-2

F3-1

F3-2

F3-3

F3-4

F4-1

F4-2

F5-1

F5-2

F6-1

F6-2

F7-1

F7-2

F7-3

F7-4

F7-5

F7-6

F7-7

F7-8

F7-9

F8-0

F8-1

F8-2

F8-3

F8-4

F8-5

F8-6

F8-7

F8-8

F9-1

F9-2

F9-3

F9-4

FA-0

FA-1

FB-0

FB-1

Motor only

Motor with Limit Switch

Motor with Hall sensor

Dual Gate

Single Gate

100% Full speed

80% Full speed

Function ON

Function OFF

70% Full speed

50% Full speed

2 sec

3 sec

4 sec

5 sec

6 sec

7 sec

8 sec

9 sec

10 sec

Function OFF

3 sec

10 sec

20 sec

40 sec

60 sec

120 sec

180 sec

300 sec

Mode 1

Mode 2

Mode 3

Mode 4

Function OFF

Function ON

Function OFF

Function ON

1. The factory setting is "F1-1".

1. The factory setting is "F2-1".

1. The factory setting is "F3-1",

2. F3 setting is for F1-1 Motor only and F1-2 Motor with

Limit Switch

1. The factory setting is "F4-1".

1. The factory setting is "F5-1".

1. The factory setting is "F6-2".

1. The factory setting is "F7-1".

1. Auto-close mode activates when the gates move to

the end position or stopped manually. If the transmitter,

push button, or the key selector is activated before the

auto-close counting, the gate will close immediately.

2. The factory setting is "F8-2".

1. The factory setting is "F9-1".

1. When funciton on and push B key in the transmitter,

one gate will open partically.

2. The factory setting is "FA-1".

1. When function ON, the light will flash before the gate

operate 3 seconds. If set OFF, the flash light will operate

with motor in the same time.

2. The factory setting is "FB-0".

Brand	PowerTech
Model	PC190
Category	Gate Opener
Language	English

PowerTech PC190 User Manual

Table of Contents

Questions and Answers:

PowerTech PC190 Specifications

Related product manuals