Pro-Form Carbon CX User Manual

5
PART IDENTIFICATION CHART
Use the drawings below to identify the small parts needed for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the
key number is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if it
has been preassembled. Extra parts may be included.
M6 Bolt Set (70)–2
M10 x 25mm
Screw (69)–4
M4 x 20mm
Screw (80)–1
M6 x 12mm
Screw (79)–4
M4 x 12mm Blunt
Screw (81)–8

Pro-Form Carbon CX Specifications

General

Brand	Pro-Form
Model	Carbon CX
Category	Exercise Bike
Language	English

Summary

CAUTION

WARNING DECAL PLACEMENT

Warning: Misuse and Safety

Safety warning about misuse, reading manual, and user restrictions on usage.

Warning: Keep Clear of Moving Parts

Safety warning to keep hands and fingers away from specific areas of the bike to prevent injury.

IMPORTANT PRECAUTIONS

BEFORE YOU BEGIN

ASSEMBLY

HOW TO USE THE EXERCISE BIKE

How to Use the Brake Knob

How to change resistance and stop the flywheel using the brake knob.

HOW TO USE THE CONSOLE

How to Use the Manual Mode

Guide to operating the console in manual mode, including resistance adjustment and system calibration.

Measure Your Heart Rate

HOW TO USE AN iFIT WORKOUT

Start the Workout

Connect Heart Rate Monitor to Console

MAINTENANCE AND TROUBLESHOOTING

How to Maintain the Exercise Bike

Routine maintenance, cleaning, and care instructions for optimal performance and longevity.

How to Troubleshoot the Console

Steps for console display issues, low batteries, and recalibrating the resistance system.

How to Adjust the Reed Switch

Adjusting the reed switch to ensure accurate feedback from the console during workouts.

How to Adjust the Drive Belt

Adjusting the drive belt if pedals slip during use.

EXERCISE GUIDELINES

Exercise Intensity

Finding proper exercise intensity using heart rate zones for fat burning and aerobic exercise.