Protocol neo-drone AP User Manual

NOTE
1. Turn on the controller; if, after 30 seconds, it has not recognized the
drone, turn off the controller to retry synchronization.
2. If the Neo-Drone AP is unsteady in flight, it may not have been able
to sync horizontally. Power down both drone and remote and
restart pre-flight procedure.
STARTING THE ENGINE; ENGINE IDLE
After synchronizing the drone, press the unlock button to go into Idle mode.
The blades will rotate but the drone will not lift.
*OPERATION INSTRUCTIONS ON THE NEXT PAGE.
1. Turn on the drone and place it on an even surface. The white lights are
at the front of the drone and the green lights are at the back.
2. Turn on the remote control.
3. The light on the remote will flash as the drone and remote are syncing.
4. Push the throttle up and then down to sync. You will hear 2 beeps and
the light will go steady.
5. Press the unlock button to go into idle mode.
Tip: When syncing your drone keep it in a horizontal position for stable flight
START-UP PROCEDURE
6

Protocol neo-drone AP Specifications

General

Brand	Protocol
Model	neo-drone AP
Category	Drones
Language	English