1. Make sure the drone is turned off.
2. Connect the USB charging cable to the drone.
3. Plug the charger into a USB port. The USB light will turn off while
charging and will turn on once fully charged.
Charging time: approximately 30 minutes --- Flying time: approximately
6 minutes
CAUTION WHEN CHARGING
1. When charging, place product on
a dry, well-ventilated surface and keep away from heat sources.
2. Always use adult supervision while charging.
3. In order to increase battery longevity, avoid repeat charging and
excessive discharging.
4. As battery temperature is high immediately after flight, charge after
cooling down for higher efficiency.
5. Do not strike or subject battery to hard impacts or sharp surfaces.
6. Do not use any other charger than that which is supplied with
this item.
7. Do not use or leave battery near a heat source such as fire or space
heater; exposure to heat may result in reduced performance or in
some cases dangerous conditions.
8. If battery is left in charging state for an extended period of time after
being fully charged, the battery may automatically discharge.
9. Never leave the battery unattended during charging.
10. Do not disassemble battery.
11. Do not submerge battery in water.
*Battery: Li-Po, 3.7V, 150mAh
DO NOT CHARGE OVERNIGHT OR
BEYOND THE CHARGING TIME
STATED. DO NOT LEAVE BATTERY
UNATTENDED.
REMOTE BATTERY INSTALLATION CHARGING THE DRONE BATTERY
5
To Next Page
Loading...
Need help?
General