EasyManuals Logo
Home>Pulsar>Portable Generator>PG6580BCO

Pulsar PG6580BCO User Manual

Pulsar PG6580BCO
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
11
ASSEMBLY
Never handle the generator, electronic devices, or any cord while standing in water, while barefoot, or when hands or
feet are wet.
Always keep the generator dry. Never operate generator in rain or under wet conditions.
Use a ground fault circuit interrupter (GFCI) in a damp or highly conductive area, such as metal decking or steel
work.
Never plug electronic devices into generator having frayed, worn, or bare wires. Never touch bare wires or make
Never permit a child or unqualified person to operate generator. Keep children a minimum of 10 feet away from the
contact with receptacles.
generator at all times.
If using the generator for back up power, notify the utility company.
If connecting generator to a building’s electrical system for standby power, you must use a qualified electrician to
install a transfer switch. Failure to isolate the generator from the power utility could result in serious injury or death to
electric utility workers.
WARNING!
This generator produces a very high voltage which could result in burn or
electrocution causing serious injury or death.
Connecting Generator to an Electrical System
a transfer switch. The power from the generator must be isolated from the circuit breaker or alternative power source.
If connecting generator to a building’s electrical system for standby power, you must use a qualified electrician to install
The connection must comply with all electrical codes and applicable laws.
Fig 6Fig 5
You must add oil before first operating this generator. Always check oil level before each
operation.
DO NOT USE E85 FUEL IN THIS UNIT. IT IS A VIOLATION OF FEDERAL LAW AND
WILL DAMAGE THE UNIT AND VOID YOUR WARRANTY.
CAUTION!
Set generator outdoors that is well ventilated.
Remove fuel cap.
Insert a funnel into the fuel tank and carefully pour gasoline into the tank until fuel level reaches 1 ½ inches below the
top of the neck. Be careful not to overfill the tank to provide space for fuel expansion.
Adding Fuel (See fig 6)
10W30 OIL
Gasoline
Unleaded

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pulsar PG6580BCO and is the answer not in the manual?

Pulsar PG6580BCO Specifications

General IconGeneral
BrandPulsar
ModelPG6580BCO
CategoryPortable Generator
LanguageEnglish

Related product manuals