Manual for Advance 6T series
#"First (Second, Disabled Selects Your Boot Device Priority. It could be
Third) Boot Device Floppy Disabled, Floppy, LS120, ZIP100, HDD-0, HDD-1,
HDD-2, HDD-3, SCSI, CDROM, LAN.
#Boot Other Device Enabled Boot other Device enabled.
Disabled Boot other Device disabled.
#" Swap Floppy Enabled Exchanges the assignment of A&B floppy drives.
Drive Disabled The assignments of A&B floppy drives are normal.
#"Boot Up On Keypad is used as number keys.
Numlock Status Off Keypad is used as arrow keys.
#"Gate A20 Normal The A20 signal is controlled by the keyboard
Option controller or chipset hardware.
Fast The A20 signal is controlled by Port92.
#"Security Option System Selects whether the password is required every
Setup time the system boots or only when you enter
setup.
#"OS Select For Non-OS2 If your operating system is not OS/2, please select
DRAM>64MB this item.
OS2 If system DRAM is more than 64MB and the operating
system is OS/2, please select this item.
#"HDD S.M.A.R.T Enabled Enables S.M.A.R.T hard disk support.
Capability Disabled Invalidates this function.
#"Video BIOS Enabled Video BIOS will be copied to RAM. Video Shadow
Shadow will increase the video speed.
Disabled Invalidates this function.
#"C8000~CBFFF Enabled Optional ROM will be copied to RAM by 16K bytes
Shadow: per unit.
DC000-DFFFF
Shadow: Disabled Invalidates this function.
#"Delay For HDD 0~3 Sets the pre-delay time for hard disk to be
(Secs): accessed by the system.
#" Show Bootup Enabled The logo will be shown when system boots up.
Logo Disabled The logo will not be shown when system boots
up.
#"Flash Write Enabled This option is for protecting the system BIOS from
Protect being attacked by severe virus such as CIH.
Disables you to upgrade the BIOS.
Disabled Enables you to upgrade the BIOS.
Chapter 3
To Next Page
Loading...
Need help?
General
