Configuration
To operate the SMS Lite, the device must have a mobile number registered as ‘Phone 1’ referred to as
Ph1. You must register this number before you can configure any of the inputs or outputs.
The device can have up to 4 phone numbers registered. It is recommended that Ph1 is the main
contact as any alarm escalations programmed will step in numerical order Ph1, Ph2, Ph3, and Ph4.
If there is no response, the next number in the list is sent a notification after 10 minutes or if a busy
message is received from the previous phone the next person is also notified.
Register Phone 1 (Ph1) – Master User
Use the following procedure to program up to 4 individual phone numbers.
1. Locate the PIN (Personal Identification Number) printed inside your SMS Lite case.
The PIN in this example is 12345.
2. Compose text message to the SMS Lite mobile number in the following format:
#[PIN][space]Ph1:number=0123456789[dot] (e.g. #12345 Ph1:number=027987654.)
3. A confirmation text will be sent to you acknowledging a configuration change.
Each configuration command must be finished with a full stop (.)
The PIN is used each time a configuration change is made
A setting can be overridden by sending a new configuration message. A configured input, output, or phone number
can also be cleared by sending a configuration message with a blank value:
#[PIN][space]Ph2:number=.
To Next Page
Loading...
Need help?
General
