6-68061-01 Rev A, December 2013
*6-68061-01*
© 2013 Quantum Corporation. All rights reserved. Quantum, the Quantum logo, DLT, DLTtape, the DLTtape logo, SuperLoader,
Scalar, DXi, StorageCare, StorNext, GoProtect, and Vision are registered trademarks of Quantum Corporation and its affiliates
in the United States and/or other countries. All other trademarks are the property of their respective owners. Quantum
specifications are subject to change.
Quantum SuperLoader 3:
Rackmount Replacement
Follow the steps in the document to replace a rackmount for your
SuperLoader 3:
To replace the rackmount, refer to the following sections:
• Preparing to Replace the SuperLoader 3 Rackmount on page 1
• Removing the SuperLoader 3 from the Rackmount on page 4
• Replacing the SuperLoader 3 In a New Rackmount on page 10
• Completing the Installation on page 12
Preparing to Replace the SuperLoader 3 Rackmount
Note: Read this entire document before beginning any of the procedures.
Safety Precautions Before beginning a rack mount installation, complete the following safety
precautions:
1 Lower the cabinet feet.
2 Extend the cabinet anti-tip device, if available.
3 Ensure that the cabinet and all rack mounted equipment have a reliable
ground connection.
4 If you have made any changes to the location of your SuperLoader 3, verify
that the total current of all rack mounted components (including the
To Next Page
Need help?
General