28
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com
MotionSensor may mistakenly start
when:
• background is plain, like a white wall,
or has distinct vertical, horizontal, or
slanted stripes, like a venetian blind.
• brightness suddenly changes.
MotionSensor may not start when:
• motion is very slow or fast.
• moving object is very small.
• motion occurs only in 1 corner of
viewing area.
• in poor lighting (in this case,
MOTIONSENSOR flashes).
• background is plain, like a white wall,
or has distinct horizontal or vertical
stripes.
MotionSensor
Before you begin...
• Connect Camcorder to power source.
Use AC Adaptor for longer recordings.
• Insert cassette with record tab (page 10).
• Set POWER to CAMERA.
• Securely position and aim Camcorder.
1Press MENU for
MENU mode. Press
UP or DOWN to select
MOTIONSENSOR .
2Press DISPLAY to select ON.
3Press MENU for MotionSensor stand-by
mode. (If cassette is not inserted, “
”
will flash.)
• Recording will start about 3 seconds
after motion is detected.
• Date and time are recorded if displayed
in EVF or LCD monitor (page 14).
• Recording stops about 30 seconds after
motion ceases.
To cancel MotionSensor Mode, set
POWER
to OFF.
Note:
• MotionSensor recording starts if Camcorder
is bumped or repositioned.
• This feature is not available during normal
recording.
• While in MotionSensor stand-by, the
following functions are not available: Record/
Pause, Stand-by mode, Digital E.I.S., Video
Effects (Auto/Digital Fade).
Recording starts automatically if motion
is detected.
1, 2, 3
05.L152 Special p22-28 02.2.18, 1:38 PM28
To Next Page
Loading...
Need help?
General
