6
Warnings
The packaging material (plastic bags, polystyrene, nails, cardboard, etc.)
must not be left within the reach of children as they are a potential source
of danger.
Before connecting the machine to power supply, make certain that the
rating plate corresponds to the requirements of the electrical grid.
The power cable must lie flat (avoid curling or overlapping) in a position
which is not exposed to any impacts or handling by minors. It must not be
placed near liquids, water or heat sources, and must not be damaged (if
necessary have qualified personnel replace it).
The use of adapters, multiple sockets and/or extensions is not advised.
Whenever their use is absolutely necessary, only use products with quality
certification markings (IMQ, VDE, +S, etc.), and ensure that the power
rating stamp is higher than the absorption (A = amps) of the equipment to
be attached.
In the event of doubt or uncertainty, have qualified personnel check the
electrical power supply which must correspond to the provisions required
by the current safety regulations, including:
1. Proper heating;
2. Conductor section is suitable for the absorption capacity;
3. Efficient circuit breaker device.
Position the machine on a hydro-repellent surface (laminated, stainless
steel, ceramic, etc.) away from heat sources (ovens, stove tops, fireplaces,
etc.) and in an environment where temperature does not drop below 5 °C.
Do not expose the machine to the elements, or install it in an environment
with high humidity, such as a bathroom area.
If the need for a replacement part arises, contact a distributor or Authorised
Retailer and only used original spare parts.
The machine in its packaging is to be stored in a dry location, free from
humidity and protected from the elements. The temperature must not be
lower than +5 °C.
A maximum of four packages containing pieces of the same type may be
stacked, one on top of the other. Do not stack heavy packages on boxes of
a different type.
In the event of damage to objects or persons caused by the improper
installation or use, the manufacturer can not be considered responsible.
To Next Page
Loading...
Need help?
General
