The Monza is equipped with an
automatic milk frother for making
delicious lattes and cappuccinos.
To use the frother position the
carton of milk on the right side of
the machine and insert the silicone
tube as shown below.
There is an adjustment screw (1)
for adding air. Turn the adjustment
screw (1) clockwise to decrease
the air and then counter clockwise
to increase the amount of air.
Increasing the air will create more
bubbles and foam.
There is also an adjustment screw
(2) on the silicone tube for milk
temperature. Turn the screw (2)
clockwise to increase temperature
and counter clockwise to decrease
the milk temperature.
Pressing the milk frother button
once will give a programmed time
setting which will then turn itself off
automatically. (user adjustable)
Press the frother button twice for
continuous frothing and then press
the button again to stop frothing.
To program the frother button,
press and hold the button until the
display reads “programming” then
release. When the desired amount
of milk has been frothed, press the
button again to stop the frothing
and it will save the new setting.
Immediately after using the frother,
put the silicone tube into clean
water and press the frother button
and let it run for a few seconds to
keep the frother clean of milk.
It is very important that you follow
this cleaning step or the frother will
get clogged with dried up milk and
will no longer function.
Warning: The water from the hot
water wand is under pressure. It is
advised to use a tall pitcher or cup
when using the wand. Using too
small of a container may cause the
water to splash out and burn the
user so extra caution is advised.
To use the hot water wand press
the hot water button once. Press
the hot water button again to stop
the flow of water.
To program the hot water wand,
press and hold the hot water
button until the display reads
“programming” and then release
the button. When the water has
reached the desired level press
the hot water button again to save
the setting.