Quicksilver Activ 755 Sundeck User Manual

Quicksilver 755SD — System & Component Overview and Operaon
29
Fuel burning open ame appliances consume cabin oxygen
and release products of combuson into the cra.
Venlaon is required when appliances are in use. Open
designated vent openings while appliances are in use. Do
not use the stove or oven space heang. Never obstruct
venlaon openings.
Do not use soluons containing Ammonia.
Never use ames to check for leaks.
Anchor Windlass
Bow windlass
Windlass breaker
Windlass switch
Changing LPG Cylinders
To replace empty LPG cylinder:
1. Turn o the stove and close the shuto valve.
2. Close the valve on the LPG cylinder.
3. Remove the regulator by turning the nut clockwise.
4. Replace the empty tank.
5. Inspect the regulator. Make sure that the gasket located on the regulator nut is in good
condion. If not, replace regulator gasket or regulator itself.
6. Re-install and ghten the regulator by turning the nut counterclockwise.
7. Check for any leaks before restarng the stove.
9. Bow Anchor Windlass (oponal)
The anchor windlass located at the bow of the boat assists with the anchoring of your boat by
automacally raising and lowering the anchor. The windlass is operated from the helm.
Operaon
To operate the windlass, the windlass breaker, located on the baery switch panel, must be turned
ON. Operaon of the windlass at the helm is controlled by a momentary switch used to raise and
lower the anchor. Pushing down on the switch will lower the anchor, while pushing up on the switch
raises the anchor.
Do not use an LPG system that has leaked unl it has been
inspected and repaired by a competent person.
If a leak is detected, shut o the main LPG supply valve and
do not use LPG appliances

Quicksilver Activ 755 Sundeck Specifications

General

Brand	Quicksilver
Model	Activ 755 Sundeck
Category	Boat
Language	English